Specifications:
Signal amplifier (repealer) receives one way SPI signal, out put signal Sγmphony 4 control group, multi group Symphony of dream color striplight changes in effect, and an amplifier used for signal output viaSPI, the theorγ can be cascaded Countless signal amplifier
DC5V~24V wide range of working voltage, but it cannot regulate the output voltage. That means the output voltage of power supply must be the same as the work voltage of your LED lights. The current through the amplifier is limited, when the current consumed is high, you need to add the power supply of the
Características:
Parameter:
Working voltage: DC5V~24V
Output:4 channels
Compatibale IC type: WS2812B,WS2811,SK6812, SK6812-RGBW,SM16703,WS2813, WS2815, CS8812, AL2815, WS2801, APA102, SK9822,UCS1903, LPD6803, LPD8806, APA102
Working temperature: -20-60℃
Static power consumption: <1W
Precautions:
The controller cannot regulate the output voltage at the VCC. That means the output voltage of your power supply must be the same as the work voltage of your LED lights. If your lights need 5V input, please use a 5V power supply, don't use higher than 5V power supplyThe current through the amplifier is limited, when the consumption current is higher, you need to add power supply of the corresponding voltage additionally.
LED Strip Signal High Speed Amplifier DC5-24V
Small RGB amplifier applies to all the voltage-controlled LED controller ,it can receiv PWM(Pulse Width Modulation), each time add one RGB amplifier, the connecting number of led will be than twice, in theory, numerous RGB amplifiers can be connected Each time add one RGB amplifier, the connecting number of LEDs will be more than twice
DC5-24V LED Dimmer
Reference: 4000790784826
8Ax4 Channel Rgbw High Speed Power Led Amplifier Dc5~24V Output Pwm Dimming Signal Rgbw Power Repeater for RGBW Strip...
This kind of controller works only under DC12V-24V, which is provided by the matched controllable main power, or else the controller will be damaged. The UTP wire is connected hand in hand to make the cable, when two or more controller connected. The power supply should be off when connecting the electric wires, and it can be turned on till making sure...
It is used to receive RGBW signal from LED controller and send the signal to another group of LED source. Supply voltage: DC12V/24V Max Load Current: 6A for each channel. Total Output of Current: 24A. Output：4 circuit. Output power：max 288W(12V), max 576W(24V)
AHC4
